APPLICATIONS

Existing penetrations
Repairs
Difficult to access penetrations
Hot & cold flues
Vents & ducts

FEATURES

SPECIFICATIONS

E..P.D.M. withstands temperatures from -50 degrees C to 115 degrees C, and up to 150c degrees C intermittently

INSTALLATION INSTRUCTIONS

EPDM - Perfect for approved flues!

Dektite® EPDM polymer flashing have been officially tested by the Coal Corporation of Victoria, Australia and conform to all Australian and UK Standards on approved flue systems. Under no circumstances should any polymer flashing be installed on a non approved flue or an 'active' combustion heater flue

HOW TO RETROFIT A SQUARE PIPE

Due to the unique patented design of the Dektite® Retrofit™ a standard rule cannot be applied when sealing around a square pipe or duct. For square penetrations simply measure the side of the square, select the correct Dektite® Retrofit™ size and cut to the correct ring as shown.

Note: When flashing a square pipe a bead of silicone should be applied along the junction between the EPDM and the pipe. Do not pull back the EPDM to apply the silicone as this can affect the Dektite® seal against a flat surface.